SECTION 8

Straightening & Tying

This section covers the process of tying the system with cable ties, pulling the form together using stringlines as a guide for straightening. The section outlines the steps for securing and aligning the QuickSet system to ensure that it is properly installed and ready for the next stage of the construction process.

← BACK TO INSTALLATION GUIDE

8.1 — Important. Sucking In Form Using Stringline, Cable Ties, Tie Wire

8.2 — Reverse Tie to Pull QuickSet Out

8.3 — Tying Back to Mesh Only - Not Reo Bars

8.4 — Extended Tying Back to Mesh

8.5 — Overview of Straightening

8.6 — Close Up of Electrical Tie From Mesh to Widget

SECTION 9

Brick Rebates

Go To Next Step
Skip to Concrete Pouring Guide
QuickSet Logo

Unit 6, 20 Highgate Parkway,
Silverdale, Auckland 0932,
New Zealand

09 959 0990
Map / Directions

NEWSLETTER

Be the first to know about exciting developments, special events and more.

SITEMAP

Proudly New Zealand made and owned
© QuickSet Distribution Ltd. / All rights reserved / Privacy policy
Website by Synergy Digital

🎄 Holiday Schedule 🎄

Please note that QuickSet will observe holiday hours as follows:

Closing — Thursday, 21 December 2023 at 5:00 PM
Reopening — Monday, 15 January 2024 at 8:00 AM

We wish everyone a joyous and safe holiday season.

Thank you for your understanding, and we look forward to serving you again in the new year!

🌟 Happy Holidays from the QuickSet Team! 🌟