Formwork Assembly

SECTION 5

Formwork Assembly

This section focuses on the use of corner and joiners to secure the form to the base, and how to attach the joiners and apply adhesive.

The process involves using corner and joiners to connect forms, and attaching the joiners to the form by inserting them into slots and applying adhesive to secure them in place.

The section provides step-by-step instructions on how to properly use the corner joiners and attach the form to the base, as well as how to apply adhesive to ensure a secure connection.

This section is an essential part of the QuickSet system installation process, as it ensures that the form and base are properly connected and can withstand the weight of the concrete during the pouring process.

Additional information concerning the QuickSet Ultra Top Cap and the use of QuickSet Packers can also be found at the bottom of the page.

← BACK TO INSTALLATION GUIDE

5.1 — Corner Joiner on Form

5.2 — Clipping Form Into Base

5.3 — Attaching Corner Joiner

5.4 — Applying MS 240FC Adhesive And Fastening Corner Joiner to Form Using 16 mm Tek Screws

5.5 — Sliding H Section Join Onto Form

5.6 — Stapling and Pinning Base to Form

5.7 — Clipping Form Into H Section Joiner

5.8 — Measuring Last Section of Form for Wall

5.9 — Cutting Last Section of Form for Wall

5.10 — Inserting Last Section of Form for Wall

5.11 — Removing 20 mm of Inner Insulation from Return Piece of Form and Clipping Form into Base and into Corner Joiner

5.12 — Internal Corner Measurement

QuickSet Ultra Top Cap

QuickSet Packers

SECTION 6

Steel Reinforcement

If your project features brick rebates, we recommend that you learn more about using them with QuickSet now.